Skip to main content
Steel Tank Inspection
An ultrasonic thickness probe with couplant pressed to a ground-clean spot on painted steel

November 13, 2026 · 4 min

CO2 tank inspection: high pressure cylinders and bulk beverage tanks

Carbon dioxide is stored in two very different ways. Each has its own inspection logic, and one of them has a hazard that has nothing to do with the steel.

A question about inspecting a CO2 tank can mean a cylinder behind a bar, a fire suppression cylinder in a machine room, a welding gas cylinder, or a bulk tank refilled from a truck at a restaurant or a brewery. These are not the same container. Cylinders are high pressure vessels that are periodically requalified. Bulk beverage tanks are insulated low pressure vessels filled on site. Knowing which one you have tells you who inspects it and what they look at.

High pressure CO2 cylinders

Portable CO2 cylinders are built to Department of Transportation specifications, in steel or aluminum, and they carry stamped marks on the shoulder: the specification, the serial number, the manufacturer and the date of manufacture. Like propane cylinders, they must be requalified at intervals fixed by federal regulation, and a filler will refuse a cylinder that is out of date. For CO2 cylinders requalification usually involves a hydrostatic test, and the new date is stamped by the requalifier. The logic of reading those marks is the same as in reading the marks on a cylinder collar.

What a visual check of a cylinder looks for

Dents, gouges, bulges, corrosion and pitting, heat damage, and the condition of the valve and its safety device. Damage at the base, where cylinders are dragged and stand in water, is common. A cylinder that shows any of these is taken out of service until it has been looked at by an authorized requalifier. Cylinders should be secured upright, by chain or bracket, wherever they are used or stored.

Bulk CO2 tanks for beverage systems

Restaurants, bars and breweries increasingly use bulk CO2 systems: an insulated tank, often indoors or in a basement, filled from a delivery truck through a fill connection on the outside wall. The tank holds liquid CO2 at low pressure and relies on relief devices to vent gas as it warms. These tanks are usually owned and maintained by the gas supplier, who inspects the tank, the relief devices and the fill line as part of its service.

The hazard is the gas, not the tank

Carbon dioxide is heavier than air, colorless and odorless at the levels that matter. A leak or a relief valve discharging into a basement or a small room can displace oxygen, and there have been fatal incidents. For this reason the fire codes adopted in many jurisdictions now expect gas detection and alarms in rooms where bulk beverage CO2 is stored, along with warning signs at the entrance. Whether a detector is present, tested and audible is as important as the condition of the tank.

Fire suppression CO2 systems

Fixed CO2 fire suppression systems use banks of high pressure cylinders and are inspected and serviced by fire protection contractors under the applicable NFPA standard for carbon dioxide systems. Weighing the cylinders to check for loss of contents is part of that service, and the cylinders follow the requalification rules for their specification.

Who does what

The user checks daily what can be seen and reports damage. The gas supplier maintains bulk tanks it owns and refuses cylinders that are out of date or damaged. Authorized requalifiers test and restamp cylinders. Fire protection contractors service suppression systems. The general sorting of who inspects which kind of tank is in who inspects what.

How this relates to steel storage tanks

Atmospheric storage tanks, the main subject of this site, are inspected under different standards and by different people. What carries over is the discipline: know the code the vessel was built to, keep the records of each check, and set the next check from what the last one found. That approach runs through inspection planning.

Not sure which rules apply to your tank?

Describe the tank, what it holds and why the question came up. Four questions, then a call.

Free and with no obligation: we call you back to confirm the details, then, with your OK, your request goes to one certified inspector who covers your area and follows up with a quote.